Having purchased a new tent this summer, I thought I would look a little more thoroughly at the range of pegs/stakes that I will be taking with me on my Long Walk in 2018. I have chatted before about the various pegs I have used over the years, and this has helped inform my ‘final’ choice.

As anyone who has read much from my Three Points of the Compass site will know, in 2018, it is my intention to set off from the Lizard in Cornwall, to follow the coastline, through Lands End, to Minehead (via the most southerly compass point of mainland Britain). Strike across country to Bristol, cross into Wales and then head north to and into Scotland via Lakeland. Keeping northward (with a diversion off to the most westerly compass point), I plan on visiting the most northerly point before swinging round to John O’Groats. As you might imagine, the terrain and underlying soil types are going to vary incredibly across this walk, far more so than any other hike I have ever undertaken to date.

It is so that I am prepared for whatever I am pegging down into, that my peg bag is going to show a little more variety than normal, in addition to being a little heavier that I might perhaps wish. Despite having a fairly wide variety of pegs for various ground conditions, I have chosen carefully, and concentrated on good quality products that have kept the weight as low as possible. Total weight, including peg bag, is 152g.

I anticipate good loamy soils, springy turf, grit, rocks, sand, roots, hard compacted earth, strong winds and waterlogged ground. It is obvious that no one type of peg is going to handle all of these, hence my choice. My tent is the Z Pack Duplex. I am not taking a free-standing option, my tent is erected with a peg at each corner plus one for each side that holds the doors out. Finally, a little more internal room can be gained by pegging out the sloping walls. So, six pegs as a minimum, eight pegs ideally. In addition to the eight, I want something for when the ground is soft and pegs just want to pull through the mud etc. Also, a couple of strong spears to pound into solid ground, where taking a rock to the head of any other peg I am carrying is going to shatter it or turn it into a banana. Not much to ask for is it! Additionally, there has recently appeared a new kid on the block- these are stupid light pegs and made of a traditionally fragile material. But I am including four short plastic pegs for additional support, replacement of lost pegs, or when I am stringing up a drying line or similar.

At a pinch, I also have my ti shepherds hooks that work with my cooking set-up as pot supports, these could instead be used to wiggle through a gritty, rocky ground, finding their way through tiny crevices. So while the two ti hooks are really part of my kitchen gear, I include them here. I also have my toilet trowel that can be used as a peg, or bags could also be filled and buried as snow anchors if things get desperate.

Lightweight, yet tough, peg bag from Tread Lite

I have previously used a really lightweight peg bag from Tread Lite that weighed just a single gram but I found it too fragile, so I have gone for a more robust bag from the same manufacturer. This is made of Icarex with a tougher Dyneema X Grid base where wear is greatest. Yet the peg bag still weighs less than 5 grams.

	Peg/stake	Material	number	Length	Individual weight	Total weight
	Easton nail	Aluminium/Carbon	8	153mm	6.2g	49.6g
	Clamcleats spear	Titanium	2	200mm	17.9g	35.8g
	Clamcleats Tornado	Titanium	2	183mm	18.1g	36.2g
	Swiss Piranha RT90	Plastic	4	90mm	3.2g	12.8g
	Cascade Designs Ti-hooks (potentially repurposed from stove)	Titanium	2	160mm	6.3g	12.6g
	Tread Lite peg bag	Icarex/Dyneema X Grid	1	270mm	4.7g	4.7g
						151.7g [152g]

• The Full Metal Jackets from Easton have either been shamelessly cloned by other manufacturers, or Easton are now producing them for a few of the smaller (and not so small) retailers under other names. They are an excellent and truly lightweight peg. Incredibly strong, they still have to be put in and removed with respect.
• The titanium pins I have included can take quite a bit of punishment and can easily be pounded in with a rock. You will find thinner variants of these pins on sale but these are the 5mm thick titanium Spears that have been hammered  through four inches of wood by YouTubers on a frequent basis.
• In soft ground, the thinner profile pegs shown above can be pulled out either with ease, or will struggle to hold. I wish I could justify a whole set of eight wide profile V pegs but instead, have included two Tornado pegs that can be used where it matters most, perhaps on the windward side of a tent.
• Swiss Piranha RT90 pegs are short, made of a supposedly ‘unbreakable’ plastic and, in good ground, hold pretty well. At just 3.2g each, I felt I could include four of these as back up.
• The titanium hooks that can provide pot support in my Sidewinder stove from Cascade Designs, can also be put into service as tent pegs. These thin pegs are good on gritty, rocky pitches, finding purchase where thicker pegs can prove impossible to penetrate the ground.

I am pretty sure that the above is going to be my final peg selection but do want to try this out for a few nights before committing to it. I am walking the Icknield Way Path over the course of a week in October and will be taking this set of pegs with me. I shall also be packing along two additional pegs, just to see if I am tempted to use them, or if they are required. These will be two of the excellent MSR Groundhogs. These are a tried and tested classic aluminium vaned peg.

MSR Groundhog

Aluminium

2

191mm

Individual weight:  14.3g

Total weight: 28.6g